skip to Main Content

Flashlight Holder Assembly

For bicycle mount:
Position holder on top side of handlebar with open side up. Align clamp under handlebar to match holes in holder. Insert short (5/8″) screws down through holder and clamp. Loosely attach nuts, position holder and tighten nuts.

For wall mount:
Position holder on wall stud or solid wood and mark screw locations.
Drill two 3/32″ pilot holes approximately 1″ deep. Lubricate screws with soap or grease and attach holder to wall using the two 1″ pointed wood screws.

Contents of bag:
1-flashlight holder
2-5/8″ machine screws
2-hex nuts
2-1″ wood screws (included with 40GB and 40409 holders)

Back To Top